Reference: 075705
ATHENA racing intake pipe for motorcycle 50cc MINARELLI AM6 Ø19 to 28mm with flexible Ø23mm adapter
A very well designed intake pipe, ideal for accompanying a high engine configuration.
Banner
The flexible pipe brand ATHENA racing for all minarelli am6. It will send your carburetor slightly to the left and down, very convenient to most of the am6 equipped. It works as an outlet for separated greasing depression or even lung, you can also block this decision without any problem.
It comes with an aluminum ring which is used to ask the female phbg carburetor or other type of fastener diameter 24mm, inner diameter of 19mm aluminum parts.
If you have a male carburettor (which enters the pipe) not use this ring, the pipe is provided for a carburetor-type male phbl ... fixing diameter 29 / 33mm carburetor diameter 24 to 28mm.
Installation Summary:
With ring aluminum: for carburettor female phbg ... in 19 to 21mm
Without ring aluminum: for carburettor-type male phbl, PHBH, TM24 ... 24 to 28mm
It is of excellent design, taking great vibration is very short, and the output is diffusee ... Being fully rubber gasket no need, they are integrated in the pipe, it leads in some cases heat , avoid all rebounds of gases, and it comes with necklace and a steel support for tightening in any reinforcement.
Reference: 075705
A very well designed intake pipe, ideal for accompanying a high engine configuration.
Reference: 9919270
Pipe replacement inlet diameter 24mm carburettor MIKUNI TM24 or other flexible mount models.
Reference: 2013801
A very high-end special for large carburations on MINARELLI AM6, DERBI ...
Reference: 269801
A pipe that will gain in performance while spending little.
Reference: 317.0005
Set of 2 M6 studs that can be used for many applications.
Reference: 9930900
High-end TPR intake kit, 360 ° swiveling, flexible mounting specially designed to accompany a MIKUNI TM24 carburetor or carburetor of this size on AM6 & DERBI.
Reference: 02 6639B
An intake pipe designed for large carburetion This pipe is short for faster recovery.
Reference: 494635
Optimize the performance of your mécaboite!
Reference: 215.0427
For an improved admission and a gain in performance! Adjustable 360 ° with tilt angle at 20 °.
Reference: 9906940
Ideal to accompany the carburetors 19 to 21mm on your mécaboite minarelli am6.
Reference: 1773
A quality 360 ° swivel pipe to replace the old one Supplied with two 30 and 45 ° sleeves!
Reference: 25526
A quality aluminum pipe to replace the old one.
Reference: 487209
A good quality pipe with an almost perfect finish for a price more than affordable!
Reference: LC.44.35
One of the best price / quality ratio for carburetor 28 to 35mm. Reserved for connoisseurs!
Reference: 215.0428
Ideal for equipping a large, precise and efficient engine configuration! 360 ° swivel with 20 ° tilt angle.
Reference: 9931740
TPR intake kit, 360 ° swivel, flexible assembly specially designed to accompany an OKO, PWK POLINI, FURYTECH, KEIHIN ... 24 to 28mm carburetor on AM6 & DERBI Ø34mm mounting.
Reference: 10870
A pipe with a correct finish which will allow you to mount your carburetors from 19 to 26mm.