Reference: 494635
DOPPLER 5mm Red or Black DPCPLER pipe shim with screws for minarelli am6 / DERBI / peugeot 103 casings malossi ...
Optimize the performance of your mécaboite!
Banner
Here is the intake pipe for carburetors from Ø26 to 28mm on mécaboite Minarelli AM6 from BARIKIT. It is actually manufactured by RQ. This model is a flexible adjustable model. It is very sold and used! We will recommend it on an OKO type carburation ... A user, connoisseur and experienced will not be satisfied with a pipe like this but preferred MALOSSI, TPR, POLINI ... for example, MALOSSI, POLINI, TPR ... are studied, absorb vibrations, are aligned, short and well defined.
We will regret on this pipe a mediocre finish as well as a design not studied enough… On the one hand by the finish of the base is not at the top, this base comes out in round Ø27mm ... No valves have an entry of round diffuser! The sleeve is not aligned with the base and it is Ø28mm, the finish of the sleeve is worse than the base and the latter is made of sincerely low-end rubber. An oil intake is present (surprising for a pseudo competition pipe).
In addition, the sleeve systems against the aluminum base are totally outdated! Let’s be clear, we don’t really like to sell this type of equipment, but many of you have asked for it. We therefore offer it to you. The price is quite low, this intake pipe will therefore go very well for small low-end carburetors like Oko for example.
-For carburetor from Ø26 to 28mm
- 360 ° swiveling system
- Carburetor fixing diameter: for fixing diameter from Ø30 to 34mm
-Internal output diameter 27mm
-Internal 28mm input diameter (may vary…)
Reference: 494635
Optimize the performance of your mécaboite!
Reference: LC.44.400
The must of the admission kits for large configuration with carburetor in 28 to 35mm. Reserved for connoisseurs! Hyper short, super diffusion, carburetor up to 35mm, vibration scrub ... Simply the best.
Reference: 2013801
A very high-end special for large carburations on MINARELLI AM6, DERBI ...
Reference: 2013800
The high-end and ultra-efficient Viton version!
Reference: LC.44.35
One of the best price / quality ratio for carburetor 28 to 35mm. Reserved for connoisseurs!
Reference: 467799
The unbeatable quality / price / practicality ratio for your am6 engines!
Reference: 1773
A quality 360 ° swivel pipe to replace the old one Supplied with two 30 and 45 ° sleeves!
Reference: 9929240
Replacement for TPR orientable intake pipes with MIKUNI TM 24 and OKO 28 carburettor on mécaboite Minarelli AM6 and DERBI.
Reference: 590
A pipe that will increase performance while spending little.
Reference: 9919270
Pipe replacement inlet diameter 24mm carburettor MIKUNI TM24 or other flexible mount models.
Reference: 215.0462
For an improved admission and a gain in performance! Adjustable 360 ° with tilt angle at 20 °.
Reference: 25526
A quality aluminum pipe to replace the old one.
Reference: 53405.05
Pipe of admission ideal to accompany a carburetor 17.5mm to 21mm!
Reference: 215.0428
Ideal for equipping a large, precise and efficient engine configuration! 360 ° swivel with 20 ° tilt angle.
Reference: 0211199B
21mm pipe for HONDA MB, MT, MTX 50 / MINARELLI AM6 50 ...
Reference: 467798
A good quality pipe with a near perfect finish for an affordable price.