Reference: 1297
choke spring on carburettor DELLORTO PHBG, PHBE, PHBH, PHBL ...
A small spring that is important. Ideal for lost or worn for a refurbishment cost.
Banner
Ideal in case of loss or wear, especially since it is a very special screw, complete idle screw with spring for PHBG and PHBG racing edition carburettors. Certified high quality, genuine DELLORTO .
-External diameter of the spring: 7.20mm
-Spring internal diameter: 5mm
- Spring length: 14mm uncompressed and 6mm compressed at maximum
-Screw diameter 5mm special thread
- Full screw length: 30mm
- Thread length alone: 15mm
Reference: 1297
A small spring that is important. Ideal for lost or worn for a refurbishment cost.
Reference: 16962_00
The replacement cover single screw for your carburettors DELLORTO PHBG Racing Red and Black Edition.
Reference: 09814_00
A tulip which increases the venturi effect and therefore the efficiency of your engine. In addition to this, you need to know more about it.
Reference: 9482
The replacement cover for your DELLORTO PHBG carburetors except racing black edition.
Reference: 53002_00 / 53002_78
A pack to switch your PHBG carburettors choke lever to cable choke!
Reference: 1298
The little room in which hangs the starter cable.
Reference: 129517
The only wealth screws for your PHBG!
Reference: 09597_00
The valve spring for your carbs, ideal when the handle returns badly or in the event of loss, wear, breakage...
Reference: 53129_00
Ideal in case of loss or to pass your cable as desired.
Reference: 18951-53
The replacement cover for your DELLORTO PHBG carburettors, to screw.
Reference: 52526_77
Ideal for refurbishing your standard PHBG or racing black edition.
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 09450
The replacement float for your carbs, ideal in the event of a fuel leak!
Reference: AP8106790
A tulip that increases the venturi effect therefore the performance of your engine.
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 09812
A mass-machined brass cap for your carburetors with aluminum tank or racing black edition!