Reference: 53027_00
Complete idle screw for DELLORTO PHBG carburettor
The idle screw with its spring for your PHBG carburettors!
Banner
Here is the O-ring of the richness screw on DELLORTO carburettor. Ideal for refurbishment, after loss or wear of this small seal which is necessary for the proper functioning and adjustment of your carburetor. Sold individually as presented.
Mounts on carburettor :
- PHBG / PHBE / PHBH / PHBL / PHF / PHM / VHST ...
Reference: 53027_00
The idle screw with its spring for your PHBG carburettors!
Reference: 09596_00
Ideal in case of loss or breakage.
Reference: 09811_00
The aluminum racing tank, mounts on all PHBG carburettors, to remove your jets faster, drain faster and get more strength!
Reference: 09506
Bar, axle, float holding rod for DELLORTO carb.
Reference: 4477.62
The ring which seals and tightens your intake pipes with your RIGID PHBG!
Reference: 11540
Excellent in the event of a problem or a leak in your carburetor.
Reference: 53031.78
The spare cover with screws for your DELLORTO PHBG carburettors except Racing Red and Black Edition.
Reference: 121692
The counter nut that locks your cable tension adjuster on DELLORTO carburettor.
Reference: 1263
The tension adjuster which is placed at the end of your tubes.
Reference: 1280
Ideal for refurbishment or for loss.
Reference: 343.0021
Ideal in case of loss or to pass your cable as desired.
Reference: 1298
The little room in which hangs the starter cable.
Reference: 129514
For a refurbishment at a lower cost for a perfect seal.
Reference: 01476_00
The original cap of all DELLORTO carburetor. Perfect for any loss or breakage of your old cap.
Reference: 203.1504
A machined / blue anodized part POLINI for your PHBG carburettors!
Reference: 53016_00 / B53016B
Kit of complete collar for rigid carburettor PHBG and SHBC!