ITALKIT competition SELETTRA analog ignition for KARTING 100cc 2T (IAME, BARILLA, KFS, KOMET, EUROPPA ...)

Attention, only reserved for competition, circuits ... Prohibited on open road!

*Ignition delivered without plate! Comes with a specifically machined stator which acts as a plate!

Here is the ITALKIT competition ignition for KARTING 100cc 2T. This ignition does not have a 12v output (it is therefore without power supply for headlight, pump or other). For the manufacture of this ignition, ITALKIT has put itself with a major asset, the SELETTRA brand, these ignitions are already used for competition by MALOSSI MHR or even PARMAKIT.

This is therefore a very high quality analog internal rotor ignition (fixed advance), it is really very powerful, solid and well balanced to avoid vibration. It will really allow you very high performance, we also prefer for this model to fixed analog PVL models.

It comes complete with the mass-machined plate, the high-voltage coil which has a high-voltage cable, the rotor, the stator, the screws ... But also the instructions. Otherwise, to have a circuit breaker, it's very simple, a cable comes out of the coil, just connect it to the circuit breaker, neman, to the ground ...

 

This ignition is wedged between 2.4mm and 2.7mm before TDC "top dead center") with a setting rod. ITALKIT guarantees that this ignition follows stability up to 27,000 revolutions per minute. Clearly, this ignition will be perfect on large competition configurations, it was also used on the famous MALOSSI MVR and other MALOSSI MG engines!

 

Mounts on all 100cc 2T KARTING engines such as IAME, BARILLA, KFS, KOMET, EUROPPA ...