Adjustable pipe admission kit + valves vl6 MHR Ø26 / 28mm viton racing for 50cc minarelli am6 / derbi motorcycle

The famous MHR intake kit for MINARELLI am6 engines and derbi 50cc euro 1, 2 and 3 engine ... For the more obsessed with preparation and power, even more efficient and solid than the rubber version, this Viton version has a viton racing rubber intake tube, this top-of-the-range material will absorb vibrations as much as possible, avoid any throttle rebounds… This pack consists of very large parts, the pipe is certainly the best existing model for these engines! At the same time as being fully orientable, flexible, special absorbing vibrations harmful to carburizing, the pipe is specially designed to diffuse the gas mixture without any loss !! This pipe coupled with the superb diffuser of the VL6 valves will bring you a perfectly aligned intake! The vl6 valves are racing valves equipped with drilled slat stops, very high quality 0.30mm carbon slats! This pack is already a must and is used for the cup gp 80, the mhr team carburetion pack Ø 21, 28 and 26mm. We greatly appreciated the easily adjustable pipe, the high quality VITON racing rubber, the cast / machined aluminum pipe flange mhr… In addition, this pack is very complete!

We recommend them on DELLORTO or other carburettors from Ø26 to Ø28mm. In male fixing diameter 33 to 36mm.

The assembly of the sleeve can sometimes be complex, you simply heat it with a hair dryer or heat gun at 50/60 °.

 

(* also exists in rubber version)

The 28 rubber mhr intake pack contains :

Super reinforced screws

28mm rubber intake tube

Valves vl6 complete with diffuser

Intake gaskets

Carburetor clamp

Notice

Spare parts :

Valve seal

Carburizing flange

Diffuser for dampers

Hose clamp

Complete vl6 valves