• Banner

  • -8%
kit 110cc Ø57,5mm MALOSSI cast iron for motor bike YAMAHA DT liquid 80cc LLC cooling
  • kit 110cc Ø57,5mm MALOSSI cast iron for motor bike YAMAHA DT liquid 80cc LLC cooling

Kit 110cc Ø57,5mm MALOSSI CVF cast iron for motorcycle YAMAHA DT, TZR, RD and YSR 80cc LC liquid cooling

31 4884

An excellent kit to increase the power of the famous YAMAHA DT 80cc with water cooling.

Stage 1 engine preparation
€199.99
€183.99
local_offer Save 8%
Quantity
Shipping in 1-3 days

Description

A small high quality very solid cast iron kit from MALOSSI with liquid cooling, in diameter of 57.5mm (actual 109cc), clean bore and finish good enough for a cast iron kit often much worse finished than aluminum. It has 6 transfers and a very wide normal exhaust. Its diagrams are well defined to have a maximum of torque and solidity. It therefore has reduced performance and precision, but a longer service life and a much lower repair cost in the event of tightening. It is certainly the best 110cc cast iron kit on the market for YAMAHA DT, TZR, RD, YSR ... 80cc LC .

 


The piston in two segments for maximum torque. We recommend it for road or regular use, many kilometers while having good power, good speed and excellent torque. Aesthetically it is quite ordinary, size identical to the origin, marked MALOSSI.

 


 

Transfers are increased in order to allow maximum performance, you will recognize on this product the head start of MALOSSI in terms of treatment, architecture and finish ... It is above all a good basis for preparers. To top it off, MALOSSI delivers you a jet for the original carburetor.

 

 

We recommend it with at least : good muffler, racing candle, quality oil.

The pack contains :
- piston pin original diameter (12mm) reinforced / treated
-2 piston clips (pin rings) type C
-piston bi segment d.57.5mm
-2 single flat segments d.57.5mm
-cylinder in cast iron 6 transfers, normal exhaust d.57.5mm
-pack reinforced joints
-1 jet for original carburetor

Mounts on :
YAMAHA TZR 80cc
YAMAHA TZR F 80cc
YAMAHA DT LC 80cc
YAMAHA YSR 80cc
YAMAHA RD 80cc LC
YAMAHA RD 80cc MX ....
In liquid cooling!


As an option we offer you a stage 1 preparation, this preparation is a modification of the channels and the exhaust port by increasing the diagrams and improving the duct, it increases the performance of the cylinder. An improvement to the piston and the bottom of the skirt is also included in this modification. Allow a little extra time for this preparation!

Product Details
31 4884
20 Items
New product
You might also like
14 other products in the same category: