Kit 80cc BIDALOT RACING FACTORY Ø47,6mm 2015 aluminum DERBI euro 3

RRD-ID:18224

A high-performance and robust kit, the famous BIDALOT RACING FACTORY has nothing to prove!

More details

manufacturers : BIDALOT
BIDALOT BIDALOT

259,90 € 259.9 tax incl.


Availability: Home in 2 to 5 days


Here is the new high engine BIDALOT FACTORY RACING 2015 80cc in diameter Ø47,6mm for mécaboite driving DERBI euro 3. This kit reaches the capacity of 80cm3 with the stroke crankshaft 44,90mm ref. 12100880. Developed and studied by BIDALOT, this set is specially designed for circuit racing, runs ....

Many changes were made ​​as the 6 transfers and exhaust to strip corrected and revised upwards. All adapted to the bore diameter 47,6mm. These changes were well on a single goal, further optimize the high-rpm performance while maintaining maximum torque and power at low and mid range.

His is a racing piston mono segment of high end model which will reduce friction and therefore increased high speeds. It is equipped with a ground-end chrome steel curved segment, its axis 13 X 39mm and reinforced clips. Delivered 100% complete, you will have full pack seals with different base gasket thicknesses allowing you to tweak your settings at the squish.

Another addition to this high engine was brought directly into the design of the cylinder which is seen adding 4 fixing screws for the cylinder head stud. The cylinder is obviously still in aluminum with its specific treatment and coating nikasil. The cylinder head stud preserves its high compression combustion chamber and is accompanied by the famous blue head cover billet.

Comes with all the necessary screws and bolts (studs, nuts ...) for assembly of this kit. A leaflet in French will accompany you in the assembly with the recommendations of the brand BIDALOT for rigging the top engine.

This pack contains:

Aluminum master cylinder 6 large transfers exhaust with bar Ø47,6mm
Blue bolt -Couvercle machined aluminum
-Plot Cylinder head with high compression polished room
-piston Mono segment Ø47,6mm
-Segment End chrome Ø47,6 x 0,8mm
Piston -Clips C
Axis-piston Ø13 X 39mm
-X4 Lengths cylinder studs 110mm X Ø7mm
-Écrous Bolts, cylinder head bolts
-6 Seals aluminum base reinforced with different thickness
-Joints Yoke rings
-Notice Information, mounting
-Autocollants

Optional we offer a preparation course 1, this preparation is a modification of the channels and the exhaust port by increasing the charts and improvement of the duct, it increases the cylinder performance. Improved piston and bottom skirt is also included in the amendment. Allow a little extra time for this preparation!

No customer comments for the moment.

Only registered users can post a new comment.

21 other products in the same category:

Previous
Next

Search

Cart  

No products

Shipping 0,00 €
Total 0,00 €

Prices are tax included

Cart Check out

Categories

Pay with credit card

CMCIC3_payment

Manufacturers



Original design by Radius design modified by
By ChapodepaY