• Banner

Kit 70cc Ø46mm AIRSAL T3 W aluminum air with variator flange + rollers Peugeot Fox & Honda wallaroo
  • Kit 70cc Ø46mm AIRSAL T3 W aluminum air with variator flange + rollers Peugeot Fox & Honda wallaroo

70cc Ø46mm AIRSAL T3 W aluminum air kit for Peugeot Fox & Honda wallaroo

02042346

Kit gives excellent power and torque strength at low prices!

Engine preparation
€58.33
Quantity
Shipping in 1-3 days.

Description

Attention, not approved on road, only reserved with the competition.

Here is the AIRSAL T3 kit with admission W. This model is for Peugeot Fox and Honda Wallaroo mounted air cooling. Perform much better than 50cc and yet so inexpensive kit ... It was planned to have the performance, torque and especially preserving a maximum solidity with a simple installation! Clearly this kit does not require large equipment to function properly!



A relaxing escape, a reinforced crankshaft with a small 17mm carburetor in ample enough has run this cylinder. Admission W will allow a formal quality improvement report by scanning a single rear transfer, it will also allow to have a wide inlet with a small back transfer, the system also works great on the casings 2 transfers PEUGEOT first generation. Lateral transfers are two in number, you will by a touch up your casings to align this kit, it works very well on original casings.



The piston is a model Bi segment with a bulging chrome for the top. Bi segment will slow down the race and offer more torque / strength in spite of the high speed. The piston has undergone a peening on the cap, this type of act is done to avoid detonation. The diagrams are quite high in relation to many 70cc market, oval exhaust is a normal model. In short, this high engine will be a good companion for the roads of the country which authorizes because it is very strong, torquey and his recovery is good! The increase in power next to a source will be very well felt. A superb quality / price / performance. Non contractual picture Warning saggy and the rollers are no longer comes with!



We recommend to accompany this kit with at least: exhaust of relaxation, reinforced crankshaft bearing clearance C3, carburation in 17mm PHBG 19 PHBG + pipe + 0.30mm blade of carbon valves, index 9 at NGK spark plug, cylinder head d.46mm (the POLINI fontione fine).

The pack contains:

X2 segments Ø46mm X 1,5mm
X1 dual piston segment
X1 piston pin
X2 crab piston clips
X1 gasket
X1 admission T3 cylinder 70cc air W

!!! think to buy a cylinder base gasket
!!!




Optional we offer a preparation course 1, this preparation is a modification of the exhaust port by increasing the charts and improvement of the duct, it increases the cylinder performance. Improved bottom skirt is also included in the amendment. Allow a little extra time for this preparation!

Product Details
02042346
3 Items
New product
16 other products in the same category: