Banner
A single high compression cylinder head for kit 80cc Ø50mm aluminum AIRSAL. Ideal in case of breakage, crack or heater that just do the bolt will no longer be flat so a premature wear of the joints.
Cylinder head of replacement for kit AIRSAL mono-segment 80cc Ø50mm on engine DERBI euro 1 and 2. The cylinder head is a model high compression incoming chamber, attention, do not place on the other kit, the chamber angle is specifically calotage for mono-segment.
Reference: 14089950
A complete seal pack of good quality, ideal for reassembling your engine without leakage.
Reference: 04081548
The cylinder head replacement kit for AIRSAL 48mm, 70cc on DERBI euro 1 & 2!
Reference: 9918250
Ø47mm spare cylinder head for Top Performances cast iron kit, DR Racing 70cc.
Reference: CU.12.85
The replacement stud cylinder head for the 80cc ITALKIT aluminum kits DERBI euro 1, 2, 3 & 4.
Reference: H04089147
Ideal for refurbishing after breakage, wear, tightening ... on your 70cc kit Ø47mm cast AIRSAL.
Reference: 04083750
The replacement head for kits 80cc two-segment AIRSAL on DERBI euro 1 & 2!
Reference: 04083448
The AIRSAL spare bolt for 48mm kits 70cc on DERBI euro 1 & 2!
Reference: CUL-997-43
Complete cylinder head replacement in 2 parts, special for the top motor racing 43mm, 50mm 85cc.
Reference: 04080945
Ideal for refurbishment after breakage, wear, tightening ... on your 65cc kit Ø45mm AIRSAL aluminum.
Reference: 23162.04
Ideal in case of breakage or wear of your old cylinder head! Top-of-the-range stud model for PARMAKIT 90 to 110cc kit.
Reference: 23152.04
PARMAKIT spare cylinder head for 70cc Ø47mm kit on DERBI euro 1 & 2 engine.
Reference: CU.12.06
Cylinder head of replacement for high engine 70cc 47mm diameter. High compression quality aluminum model.
Reference: S410105308001
Ideal replacement in case of breakage or advanced wear of your old room.
Reference: 11220870
Ideal to give a racing look to your engine or wear!
Reference: CU.12.78.5
Ideal in case of breakage or wear, high quality cylinder head stud, ITALKIT Competition model for 80cc kit and pack Ø47,6 mm 43.00 mm long race on DERBI euro 1 & 2.
Reference: 23156.04
Ideal in case of breakage or wear of your old cylinder head! Model with top stud for kit 80cc race 40mm PARMAKIT.
Reference: 04085850
Cylinder head of replacement for kit 80cc Ø50mm AIRSAL Sport.
A single high compression cylinder head for kit 80cc Ø50mm aluminum AIRSAL. Ideal in case of breakage, crack or heater that just do the bolt will no longer be flat so a premature wear of the joints.
