ITALKIT SELETTRA ANALOG ignition internal rotor scooter KYMCO VITALITY, AGILITY, DINK, PEOPLE ... 50

Attention, only reserved for competition, circuits... Prohibited on the open road!

Here is the ITALKIT ANALOG competition ignition for KYMCO scooter engine, air cooling only (a version for liquid cooling exists). This ignition does not have a 12v output (therefore it is without power supply for headlight, pump or other). For the manufacture of this ignition, ITALKIT has put together a major asset, the SELETTRA brand, these ignitions are already used for competition by MALOSSI MHR or PARMAKIT.

This is therefore an analog internal rotor ignition (fixed advance) of very high quality, it is really very powerful, solid and well balanced to avoid vibration. It will really allow you very high performance, we also prefer this model to fixed analog PVL models.

It comes complete with the machined plate, the high voltage coil which has a high voltage cable, the rotor, the stator, the screws, a ground braid... But also the instructions. Otherwise, to have a circuit breaker, it's very simple, a cable comes out of the coil, just connect it to the circuit breaker, neman, to ground... This ignition is set at 18° (i.e. 1.4mm before TDC "top dead center") with a setting pin.

ITALKIT guarantees that this ignition follows stability up to 27,000 revolutions per minute. Clearly, this ignition will be perfect on large configurations, not too pushed either, afterwards it is better to switch to variable which guarantees monitoring in the highest revs without loss of torque thanks to the self-shifting according to the revs. motor.

 

Mounts on scooter with vertical or horizontal minarelli engine air cooling only (a special version exists for liquid / lc).

 

Mounts on KYMCO air cooling :

KYMCO VITALITY 50 2T

KYMCO AGILITY 50 2T

KYMCO PEOPLE 50 2T

KYMCO DINK 50 2T

KYMCO TOP BOY 50 2T

KYMCO SUPER 8 and 8 50 2T

KYMCO BET & WIN 50 2T

KYMCO MXU 50

KYMCO MAXXER 50

KYMCO HEROISM 50 2T

KYMCO SNIPER 50 2T