Kit 70cc Ø46mm AIRSAL T3 W aluminum liquid with cylinder head Peugeot 103, fox & wallaroo

Attention, not approved on road, only reserved with the competition.

Here is the AIRSAL T3 kit with admission W. This model is for Peugeot 103 mounted liquid cooling. It was scheduled for the performance, torque and especially preserving a maximum solidity with a simple installation!

 

Clearly this kit does not require large equipment to function properly! A relaxing escape, a reinforced crankshaft with a small carburetion 17,5mm PHBG amply suffice to make good walking / talking this cylinder.

 

 

Admission W'll allow a formal quality improvement report by scanning a mere transfer back, it'll also allow to have a wide inlet with a small back transfer, the system also works great on the casings 2 transfers PEUGEOT first generation.

 

Lateral transfers are two in number, you will by a touch up your casings to align this kit, it works very well on original casings. The piston is a model Bi segment with a bulging chrome for the top. The bi segment ralentiras the race and must offer more torque / strength in spite of the high speed. The piston has undergone a peening on the cap, this type of act is done to avoid detonation.

 

The diagrams are low enough (though the admission has not be greatly retouched if you increase the exhaust diagram), the exhaust is an oval normal model. The cylinder head is improved compared to the original level cooling, it features a high compression truncated polished Ø46mm room, this room is obviously highly compressed to accompany torquey diagrams and bi segment of the cylinder / piston. In short, this high engine will be a good companion for the roads of the country which authorizes because it is very strong, torquey and his recovery is good! The increase in power next to a source or a 50cc kit squeezed very well felt. A superb quality / price / performance.

 

 

We recommend to accompany this kit with at least: exhaust of relaxation, reinforced crankshaft bearings C3 play, carburetion with 17,5mm pipe and valves 19 for PHBG 0.30mm carbon index candle 9 at NGK.

The pack contains:

X2 segments including one chrome

X1 dual piston segment

X1 piston pin

X2 crab piston clips

X1 pack complete joint

X1 user manual

X1 admission T3 cylinder 70cc liquid W

X1 cylinder head high compression

 

Optional we offer a preparation course 1, this preparation is a modification of the channels and the exhaust port by increasing the charts and improvement of the duct, it increases the cylinder performance. Improved piston and bottom skirt is also included in the amendment. Allow a little extra time for this preparation!