TEKNIX original type engine casings for Peugeot 103 all models

Here is a very economical part but yet of very good quality! This set of housings is really complete and all for a ridiculous price… Perfect for starting over! Ideal for making good engine preparation on a clean base, especially since this set of housings is very thick and leaves room for machining! The housings are Peugeot 103 type models, they are not the real Peugeot housings….

They are a different exterior shape and are thicker, the alloy is of high quality, the workings are good, and the workmanship is quite good. They are delivered with a high quality viton spy seal set, an ignition foam, a set of reinforced riveted steel cage bearings (to be changed if you have a large configuration). There is also a spy plate for the drive side with its screws. We regret all the same that the bearings are pre-assembled! In mechanics normally we mount the bearings on the vilo to then mount the vilo on the previously heated casings for assembly without forcing! This pack also has a crankcase gasket, 4 high quality reinforced studs and all the crankcase screws / washers / nuts !!!!

 

Housings made in Asia, of much better quality than original Turkish housings like P2R for example! They lend themselves well to engine preparations even an alignment with an AIRSAL T6 large transfers.

 

The pack contains :

X1 set of reinforced riveted steel cage bearings
X2 full original type engine casings
X2 seals spy racing viton
X1 foam on the ignition side
X1 set of 4 studs
X1 complete set of screws
X1 complete washer set
X1 complete nut set
X1 drive spy support plate
X2 screws for drive plate

Spare parts :

Crankcase gasket

Ignition spy seal

Variator spy seal

Variator bearing

Ignition bearing

Bearing kit + spy

Stud set