Carters embedded engine support engine POLINI small pack Peugeot 103 sp, mv, MVL, lm ...


The casings with big fat intake and media version "naked" for your 103!

More details

manufacturers : POLINI

186,90 € 186.9 tax incl.


Availability: Home in 2 to 5 days

The well-known and renowned POLINI casings for Peugeot 103 sp, mv, MVL, lm, ... Attention, they do not fit on PEUGEOT 103 SPX / RCX / CLIP ... For those who are eager to ask POLINI casings on their Peugeot 103 but who wish to also ask higher-end bearings as the pack we do, who also wish to ask studs and a top pitcher pedal range like MALOSSI and finally better quality oil seal as TNT we offer these casings "naked".

So are complete housings without bearings, spy, pins and without starter pedal. This has the advantage of letting you part of other hardware, but also to be much cheaper! They still have everything there in the picture, namely: screws, two intake pipes of different sizes (for a 15mm SHA and PHBG for 17.5 to 19mm), a ground strap, an adjustable spring racing engine, a muffler support bracket and spring motor, note ...

Admission is large enough, it will accept a 21mm carburetor without difficulties, the housing side is micro Billee admission to the rules of the arts and the crankshaft passing polished properly. The architecture is revisited for a better arrival / diffusion, more pre compression comblage dead volumes ... Obviously transfers casings are intended to be associated with a big kit. The pipes are however polished inside and not blasted, but a good preparer will see again at the microphone blasting before assembly!

The valves are fitted with two blades is a division of 0.35mm thick fiber, they have unfortunately not drilled slats stop. Will appreciate strongly support incorporated in the engine housings and mounted on silent blocks rigid!

Level power with a good kit, a good carburetor and change, as you say there is what you go up in relation to the very bad casings Peugeot 103 origin which have an architecture, a sweeping and very bad and badly studied admission. We will miss an alloy rather fragile, so care must be present at the assembly / disassembly!


We suggest a minimum to accompany these casings: crankshaft reinforced normal bristles Kit cylinder / piston / cylinder head racing, carburetor 15 to 21mm, candle racing, racing air filter ...

The pack contains:
2 competition crankcases
1 adjustable competition mainspring
1 ground strap
1 mainspring rod
1 hardware pack
1 pack attached paper
1 box competition valves
1 15mm intake pipe
1 intake pipe 17.5 to 19mm

No customer comments for the moment.

Only registered users can post a new comment.

14 other products in the same category:



No products

Shipping 0,00 €
Total 0,00 €

Prices are tax included

Cart Check out


Pay with credit card



Original design by Radius design modified by
By ChapodepaY