Banner
Premium Pack, essential for building a low engine crankshaft equipped with bristles (worn bearings) Ø17mm original size! C3 models polyamide cage reinforced with simple joints spy.
Set of 2 bearings + 2 joints spy reinforced high speed PARMAKIT RACING competition! For you PARMAKIT has selected the best SKF bearings and joints spy best! The bearings are original sizes Ø17mm, reinforced polyamide cage and C3 models. The spy are mere lip models.
Reference: 7961
Ideal to reinforce your low engine of minarelli with quality material.
Reference: 6616065E
C4 reinforced bearings, high precision competition!
Reference: 285.0137
Racing crankshaft spy (spi) gaskets, high-end POLINI model mounted on the clutch side.
Reference: 478939
The must of bearings and spy joints for a solid and tight assembly.
Reference: 100014
Solid bearings with good quality spy joints, ideal for small and medium configurations.
Reference: 280.0044
POLINI EVOLUTION reinforced bearing.
Reference: KCR-03
Ideal for refurbishment on your lower minarelli am6. Original reinforced sizes C3 Bearing Kit Ø17mm + joined spy Viton.
Reference: 6611566E
Reinforced bearings that will support large configurations without any problem.Available in C3 or C4 set!
Reference: P400010450003
Kit of seals spy competition, reinforced and specific high speed!
Reference: 285.0136
Spur gaskets (spinnaker) competition crankshaft, high-end model POLINI amount side ignition.
Reference: 100872
Ideal to reinforce your low engine of minarelli with quality material.
Reference: P400130400204/1
A complete seal pack for a refurbishment of your engine!
Reference: 329917
A top-of-the-range seal pack for maximum sealing and minimum friction.
Reference: 7961
C3 bearings that will support large configurations without any problems.
Reference: 282.0003
Reinforced bearings and Teflon spy seal studied for competition!
Reference: KCR-15
A premium pack, ideal to accompany an engine crankshaft configuration with well prepared in large silks (carried bearings) Ø20mm!
Premium Pack, essential for building a low engine crankshaft equipped with bristles (worn bearings) Ø17mm original size! C3 models polyamide cage reinforced with simple joints spy.
