Reference: usinage_culasse_sur_mesure
Custom cylinder head machining (squish, compression rate, etc.)
Custom machining of a cylinder head.
Banner
Set of 4 bolts reinforced with standard M7 thread, length 112.5mm. For cases MALOSSI, POLINI, origin…. From Peugeot 103, Peugeot fox and HONDA wallaroo, minarelli am6, DERBI euro 1 & 2 ... Very high quality! The general tightening recommended on a kit with this type of stud is 18 to 20nm! Consider using a torque wrench. This type of stud can withstand more than 25nm in tightening, the casing threads will give way well before them ...
Reference: usinage_culasse_sur_mesure
Custom machining of a cylinder head.
Reference: 672
Complete system at a good price and of very good quality.
Reference: 9178
Ideal in case of renovation of your engine and strongly recommended to change the top engine of your 2 wheels.
Reference: 87171100
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 472434
Ideal for redoing a cylinder in the event of primer, heating or simply to remove micro-scratches that hold the oil.
Reference: X4 12512042
Reinforced and elongated nuts to better tighten the cylinder head and more precisely. They can withstand much higher tightening torques!
Reference: 1443
Ideal in case of breakage of your muffler threads on your cylinders or simply to strengthen your assembly.
Reference: 317.0102
Quality stud and reinforced to prevent breakage or wear. Maximum tightening 18nm or 2,04mk / g. In addition to this, you need to know more about it.
Reference: 07 1928B
Special 8mm shim for long stroke crankshafts / long connecting rods RRD or MALOSSI on PEUGEOT 103.
Reference: 315.0028
Cooling screws for POLINI kit on PEUGEOT, MINARELLI ...
Reference: 486933
Reinforced cable clamp Ø6mm X L.10mm for cable diameter Ø2,5mm.
Reference: 87172000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: S.1447 - 001447 (PIAGGIO)
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 707712
An original stud from PEUGEOT ideal in case of breakage or wear of your old stud. Maximum tightening 16nm or 1,63mk / g.
Reference: 517937
Very long and reinforced, these nuts allow you to tighten with more precision and support a higher tightening torque!
Reference: 15202529
Ideal for aligning your pot to your cylinder to avoid loss of power.