Reference: 156263
Set of 4 cylinder head nuts with P2R washers m7 thread Peugeot 103 / MBK 51 / AM6 / DERBI…
Set of 4 M7 nuts with their 4 washers.
Banner
Here is an alignment game, this little game helps improve performance. For example on a Peugeot 103 / fox / wallaroo cylinder, there is a large thread to allow you to fit an exhaust with Ø32mm thread. If you install a flanged exhaust (2 fixing screws) the exhaust or the ball joint will not be aligned at all ... You will therefore install this Malossi alignment game. This game will allow a good alignment, but also no loss and that the gases go to the right place. The set is complete, it includes the ring and the gasket.
Reference: 156263
Set of 4 M7 nuts with their 4 washers.
Reference: 504674
Ideal for aligning your pot with your cylinder to avoid power losses.
Reference: 1443
Ideal in case of breakage of your muffler threads on your cylinders or simply to strengthen your assembly.
Reference: 167917
A set of reinforced and treated M6 P2R cylinder head nuts to maintain the quality of your high engines.
Reference: 517937
Very long and reinforced, these nuts allow you to tighten with more precision and support a higher tightening torque!
Reference: 707712
An original stud from PEUGEOT ideal in case of breakage or wear of your old stud. Maximum tightening 16nm or 1,63mk / g.
Reference: 8803
Reinforced cable clamp Ø8mm X L.1,3cm for cable diameter Ø3,5mm.
Reference: 317.0102
Quality stud and reinforced to prevent breakage or wear. Maximum tightening 18nm or 2,04mk / g. In addition to this, you need to know more about it.
Reference: 15202529
Ideal for aligning your pot to your cylinder to avoid loss of power.
Reference: 11700118
2 pawns to improve your assembly of your kit, casing, cylinder head...
Reference: ESP.07.116.4
The strongest with MALOSSI, support extreme tightening torques. Support ample 25nm (2,25 mkg)!
Reference: 87307000
Ideal in case of breakage, loss or worn thread of your old nut.
Reference: 19 4725
Very long and reinforced, these nuts allow tightening with more precision and withstand a higher tightening torque!
Reference: rrd-cale-1mm-103-parmakit
1mm wedge in high quality machined aluminum for PARMAKIT large transfer cylinders of PEUGEOT 103, FOX, HONDA WALLAROO. Ideal for laying down long runs to increase your charts!
Reference: ESP.07.125.4
The strongest with MALOSSI, specially lengthened for high engines with wedges for stroke or long connecting rod, withstand extreme tightening torques. Amply support 25nm (2.25 mkg)!
Reference: 87308000
Ideal in case of breakage, loss or worn thread of your old nut.